Remove Colour Cast Using channels

[Flora]

Hi everybody,

Ken,

sorry for getting back so late but I've been very, very busy (and will be for a while still....)

CJ pointed you in the right direction ... (thanks CJ!!!)

The first tutorial I read about using Apply Image (small brother of Calculations) is here.
.. and, after starting to understand what could be done with it, I started 'experimenting' with it while dealing with different problems ....

I use it regularly and it hasn't let me down yet ....

[Flora]

Originally Posted by nebgranny

Well I have been learning how to use channels a bit by what has been going on in the forum. I used your instructions Flora. For some reason the hue and sat was greyed out , but when using the other function you mentioned this is what I came up with . a little different coloring than yours . I am using CS2 and my box looked a little different than yours. Neb

Hi Neb,

what might have happened is that you were still working on the Red Channel only ... (Attachment1)

Make sure that before giong back to the Layers and opening the Hue&Saturation dialog box, you have activated all three RGB channels again .... (Attachment2)

P.S. I'm also using CS2 .... In your 'Apply Image' Box did you tick/Check the 'Mask' box under the Opacity Option?