No announcement yet.

De-gaussing your monitor

  • Filter
  • Time
  • Show
Clear All
new posts

  • Panpan
    A lot of speakers are shielded nowadays and are safe to put next to the monitor. This is especially true for center channel speakers and for internal speakers. In my system for example, only the subwoofer is not magnetically shielded.


    Leave a comment:

  • snowdog

    Putting magnets near your monitor or TV sets is a big NO NO!

    Make sure your speakers are not sitting right next to your monitor aswell.

    When you look at an all white screen of your monitor it should be all pretty evenly white with no funny coloured patches of other colours. This is called Purity.

    Most TV sets and monitors have a " De-Gaussing " coil - circuit built into them that turns on and de-gausses the monitor before the screen gets bright enough for you to see the great Rainbow light show it makes.

    If you really need to degauss the monitor screen you could use a AC Solder Gun that is pluged in ( cause of its transformer it gives off a strong magnetic field ) and start with small circles at the center of the monitor and as you back away make the circles bigger. Then once you see you are no longer affecting the screen with the Gun's magnetic feild you are safe to shut off the gun.

    Best bet get someone who knows what they're doing to do it for you!!


    Leave a comment:

  • Cassidy
    Hi Craig,

    Agree with the degaussing if it is available as a feature of the monitor (CRT only to my knowledge) and many more recent monitors automatically degauss when turned on. Insofar as seeing what a magnet does to a monitor, it is strongly recommended that such a task not be performed. You can buy dedicated degaussing guns, but if you do not know what you are doing, you can inflict far more damage. Some TVs and CRTs are actually aligned with magnets and so degaussing with other than internal degaussing (built in) can actually do more harm than good and damage the alignment.

    Would prefer to get others to check their monitor manual to see if it is a feature of the monitor. One of the greater problems people experience with magnetic buildup or even shimmer at the corner (only noticeable in peripheral vision usually) is caused by bad placement of speakers, usually too close to the monitor. Speakers contain magnets and so can alter the image both immediately and to a greater degree over time.

    For those not familiar, magnetic buildup in a monitor can resemble a shimmer in one corner or on one side and at the extreme, can resemble, bluish patches/purple or green patches, usually in the corner or corners and progressing
    Last edited by Cassidy; 09-06-2005, 08:57 AM.

    Leave a comment:

  • Craig Walters
    started a topic De-gaussing your monitor

    De-gaussing your monitor

    this kind of goes hand in hand with the calibrating your monitor thread. however, it's not quite as critical and doesnt usually need to be done as often. still, it can make a difference.

    now, someone brighter than myself can try to explain what de-gaussing means and how the need for this comes about. basically, it's just another way you monitor can get screwed up. only this time it usually involves magnetics. rather than try to explain this (which i pretty much couldnt unless i went out and did some electronics reading) i'll simply say that if you want to see what gauss is all about, put a magnet near your monitor's screen and move it around a bit. if you're using a crt type monitor you shld see things start to change color near the magnet. this can also happen on your television screen. i dont know about other types of monitors/tvs, but any that are crt (cathode ray tube) types, this can occur.

    the problem is, those swirling lines you see when you put a magnet near the monitor can actually somewhat stick and remain there. not something graphics folks want. so, you now need to de-gauss. some monitors have a built in feature which you can usually access through your monitor's control panel or menu system. see your monitor's manual to be sure.

    but, if your monitor doesnt have a de-guass feature, you'll have to find another way. one way i saw recently involved using magnets on a drill motor. you turned the drill on and the magnets revolved around in the circle and you simply held this up to your monitor and moved it around until things looked good again. sort of crude but it shld work. you could probably also buy something fancy from a Radio Shack or other electronics store or maybe even a television shop.

    like i say, this isnt something you're going to have to do a lot. if i do it once a year, that's a lot. but, if you ever get those sort of magnetic looking swirling, curling lines of color on your monitor you'll know what it is.


Related Topics


  • Jeff F
    Can Monitor Calibration Devices Flag a Bad Monitor
    by Jeff F
    I'm asking this here because I'm currently reading Richard's book on PSE 4. It occurs to me that no amount of calibration can fix a monitor for which the colors at the edge of the screen do not match the colors in the center. And I'm sure that there are other monitor problems which cannot be eliminated...
    10-08-2006, 11:25 PM
  • workharder
    Which monitor I should trust?
    by workharder
    Hi Folks,

    I'm using Dell U2711 calibrated with Spyder color, one thing that make me confuse is because my work seems very different when I open it in different computer, but in other hands, people works still fine when I open in Dell or other monitor.

    I already happy with...
    01-24-2014, 12:50 AM
  • Caravaggio
    Guidance on purchasing a monitor
    by Caravaggio
    Hi, It has been a few years since anyone has posted any recommendations on monitors for retouching. I was wondering what people's current recommendations are?

    I'm currently using an iMac, 5k, retina 27", late 2015, calibrated with colormunki, as my main monitor. I know Apple monitors...
    10-21-2017, 05:10 PM
  • micah
    help telling if my monitor is crt or lcd
    by micah
    I am trying to calibrate my monitor with the one-eye device. One of the first questions asked though was if my monitor was a lcd or crt type monitor. I thought almost all monitors were lcd, but then started to rethink it. It seems that maybe most desktop monitors (which is what I am using)...
    11-13-2003, 01:27 AM
  • Jon
    Monitor question...can you help?
    by Jon
    I just invested in a new desktop, laptop, and printer. I am also getting some new camera gear. I picked up a monitor knowing it wasn't really the caliber I wanted, but what I could afford at the time and what the salesman shot me for a price with the other stuff. It is a HP w2338h 23-inch Diagonal...
    08-05-2009, 03:50 PM